Member Panel

I dont think it my boot. It might just be that my hard drive is dusty and it cant read it. I am gonna get some air spray and spray it out. Could that be the problem?

Did you move anything around or did you use the same connections for the same devices? And do you have one HD or more and if more , whas it youre system drive system drive that got disconnected?

Also have a look in youre bios if youre drives are detected , you can also check the boot order in there.

No i did not remvoe nothing. I unplug the hardware for the screen and plg it back because it had came aloose. Then that happen. I am gonna use my lil air blower then and get all the drust out. I hope thats the problem it was just dusty. But everythng is plug back up like it supose to be. And still not worken

"NTLDR missing what is this? "

This means your PC tries to boot from a formatted disk without an OS installed on it.

So your HD is detected, I think your cables are OK.

Silly question: Is there a memory stick of a floppy drive in your PC and tries to boot from?

If not:

-Are there other harddrives in your system and your boot order changed?

-Did you put your harddrive on the correct strp? Not the the secoundary IDE instread of the primary???

Another thing is for the time being (if you have an opertaing sytem on your hard drive, is unplug your floppy drive then reboot..Your floppy drive might have went bad

NO i dont have a memory stick. I am gonna to make sure i put make sure i put them in the right strip. And do what will the fopy?

my boot is like this
1. Hard drive
2.ATAPI Cd-rom drive
3. Removable Devices

I check my hard drive and it looks like its in the right strips
But still does not work