DVD Shrink 3.2 "Cyclic redundancy check"

  1. evertsen1010

    evertsen1010 New Member

    Aug 31, 2006
    Likes Received:
    Local time:
    My System

    I can back up movies but some of the ones I really want keep telling me That DVD Shrink 3.2 failed to read D:\ "(cyclic redundancy check)"
    What does this mean?
    How do I fix it?
    I can really use the help this is an important dvd for my daughter.

  2. Hengis

    Hengis Proud PCHF'er since 2004 Tech Member Elite Member

    Jan 1, 2004
    Likes Received:
    Local time:
    My System

    Welcome to PCHF,

    A "CRC" error is most often caused by bad media - it could be any of the following:

    1. A dirty disc,
    2. A scratched disc
    3. A poor quality disc (cheap media if it happens during the "Burn" section of your work)
    4. A bad disc from the Mfgr.

    It can also be from a bad optical component in your drive. At this time I don't believe it's your drive at all.

    If you recently purchased this disc new from a store, I would return it as defective if just cleaning and the proper use of DVD Decrypter doesn't get the job done.

    I'd like you to check your DVD Decrypter's settings. First, it should be version Go to "Tools", "Settings", set everything to "Default". Then in the "General" tab change, "Removal Method" from "Normal" to "Aggressive", in "File Mode", "tick" Remove PUO's." For ripping in the "ISO Read Mode", "tick" "Remove PUO's" there also. in the "CSS" tab, under "CSS Cracking Method", choose "Brute Force ~> I/O Key Exchange" and "On Failure" choose "Yes". . IMPORTANT: In the "I / O" tab, in the bottom right, "tick" the box which says, "Ignore read errors". This is an excellent setting for dealing with scratched discs which may cause ripping problems.

    Some people like ripping with DVD Decrypter using the "File" "Mode" BUT, especially for episodel-type DVD's, I feel that nothing can beat ripping the DVD using the "ISO", "Read", "Mode". After you've ripped your disc using the "ISO" "Read" "Mode", open DVD Shrink go to File", "Open Disc Image " to locate your ISO image - after allowing DVD Shrink to load up the image, just process it as usual then burn to disc using your burner of choice.

    HINT: If you are going to burn with DVD Decrypter, DON'T FORGET TO - go back to DVD Decrypter after ripping, to reset the "Mode" from "ISO - Read" to "ISO - Write".

    Here are some other little "tricks" which may or may not help -

    The "Magic cleaning" technique: Try cleaning your DVD discs. Yea, I know they're new and clean but do it anyway. Do it a few seconds before inserting it into your DVD tray, use a disc cleaner, eyeglass cleaning solution or 99% Isopropyl Alcohol and a soft cotton cloth and rub-a-dub, dub. As soon as you're finished, "Pop" it into your DVD tray and fire up your program

    Begin by playing your DVD with your PC’s player. Play for two or three minutes then open your DVD Shrink, DVD X Copy or your weapon of choice - as soon as you begin your rip turn off your player so it doesn’t interfere. The playing before hand is only so that your ripping program can “Find” your DVD.

    "Dr. ScubaPete's, too cheap to buy the professional stuff, Recipe Book for Scratch Repair."

    To help with those small "Kiddie Scratches" on your DVD's -

    TO BE USED AS A FINAL RESORT to retrieve scratched DVD's.

    Materials needed:
    A soft cotton cloth
    Toothpaste w/Borax (Arm & Hammer may be added)
    (Brasso metal polish may be used as a substitute for toothpaste)
    Isopropanol Alcohol
    Orange Juice and Vodka

    Method: "If this doesn't work it's into the "Circular File" (an Americanism meaning "The Garbage can") with you -

    1. Place the disc on a firm soft surface.
    2.Apply a small amount of toothpaste with a small amount of Arm & Hammer Baking Soda to a clean, soft cotton cloth and apply to your DVD. Rubbing very firmly in even strokes from the center outwards towards the edge. Repeat 10 to 15 times. Do this over the entire disc turning the disc slowly in a circular manner, always going from the inside to the outer edge.

    When Finished –
    3. clean it either with a commercial unit (available at "Radio Shack" OR your local electronics store) OR clean the disc thoroughly with a clean cotton cloth moistened with Isopropanol Alcohol, Contact lens cleaner OR in a bind, you may use some Windex (Windex has some additives, coloring and the like). Clean by using a firm even rubbing motion from the center outwards towards the edgeClean the disc thoroughly with a clean cotton cloth moistened with Isopropanol Alcohol, Contact lens cleaner OR in a bind use some Windex, using a firm even rubbing motion from the center outwards towards the edge.

    Using a clean piece of cotton cloth, apply Pledge to the entire disc in the same manner as the toothpaste was applied above.

    Attempt to play disc.
    If the disc refuses to play, take 1 large 12oz. glass, add just 3 Ice cubes, too many ice cubes will "water down" the mixture rendering it unsuitable for usage, then add 70% Orange Juice and 30% Vodka. The contents are to be shaken, NOT STIRED. The glass's contents are to be liberally applied internally.

    Steps 2 through 5 may be repeated as required to recover disc.

    After 2 complete passes, step 5. may be repeated PRN. (PRN is medical lingo for "As needed" OR "Whenever you want.) :p)

    Source: AfterDawn forums.
Similar Threads
Forum Title Date
External Hardware shrink/help Mar 7, 2008
External Hardware my screen is shrinking Nov 18, 2007
External Hardware External Hard disk showing cyclic redundancy check Nov 9, 2012
External Hardware Cyclic redudancy check? Dec 20, 2008