I have started to use "selected and unselected" in Content Aware in Cyberlink PowerDirector 17 to edit clips and to try to get rid of poor scenes. I have used quite a variety of editing software in the past, but PD appears good. It is just the learning curve!

I tried to do it as described in the PD 17 Manual.

Here I have deselected:

Here I have pressed the arrow to the right of “deselected”.

Once I have selected and deselected and the scenes appear in the appropriate column, I then press OK, save and close the program.

If I open the project again, theré is no evidence that any editing/selecting was done.

What am I doing wrong?