Motherboards - Emachine T4060 stuck in startup posted in the Hardware forums; I have a emachine t4060 that turns on and starts to boot and says that the cpu has changed hit f1 to continue or del to enter setup. but the ...
I have a emachine t4060 that turns on and starts to boot and says that the cpu has changed hit f1 to continue or del to enter setup. but the keyboard does not work. cant get any further
This all started when i had audio/video card issues, i replaced it the night before and everything worked fine. the next day we had a power outage but the computer was off but plugged in. now i cant get it past that screen any ideas?
1. On the motherboard there is a small watch battery. Remove this battery along with the power cable from the power supply. Hold down the power button to fully discharge the system. Wait 2-3 minutes then reinstall the battery and plug in your system. Your reset is now complete
2. Some motherboards have a 3 pin jumper by the battery. Lets say that the jumper is on pins 2 and 3. Remove the jumper while the machine is OFF and place onto pins 1 and 2. Power on your machine for a minute. (Note: Your system will not POST). Shutdown your machine and put the jumper back to pins 2 and 3. Your reset is now complete
PC Help Forum
» Hardware
» Motherboards
»
Emachine T4060 stuck in startup
Emachine T4060 stuck in startup
So no keyboard response at all have you tried another one also might be worth reseting the bios
Linear Mode
