Hi,
Are there anyone out there that can help me with the following issue.
To get into the BIOS I am told that I should keep F1 down under boot-up. That´s fine but I will then end up in the "Easy setup program" and that gives me very few option to change.
Are there anyone that can tell me how to reach the BIOS and not to end up in the "Easy set-up program"?

/Claes

When you are booting up a lot of BIOS setups list the key to get into the BIOS on the first screen on boot (called the POST). Is this not present?

Hi guys....Most IBMs use F2 or F12 to get into the BIOS.

Push either of these buttons at POST

Hi Guy's if thet don't work try this recommended by IBM

BIOS Setup

Most systems have the setup program built right in to the ROM BIOS software. These built-in setup programs are activated by a key sequence usually entered during the POST. Most systems show a prompt on the screen during the POST indicating which key to press to enter the BIOS Setup.
The major vendors have standardized on the following keystrokes to enter the BIOS Setup:

• For AMI BIOS, press Del during POST.
• For Phoenix BIOS, press F2 during POST.
• For Award BIOS, press Del or Ctrl+Alt+Esc during POST.
• For Microid Research BIOS, press Esc during POST.

Here's some more to try

Table 3.4 Entering BIOS Setup on IBM ThinkPads

Current ThinkPad Models
To Run BIOS Setup:
240 series 390 series 570 series i Series 1200 i Series 1300 i Series 1400 i Series 1500 i Series 172x A20, A21, A22, A30, A31 R30, R31, R32, S30, S31 T20, T21, T22, T23, T30 X20, X21, X22, X23, X24, X30, X31
Power on. Press F1 when the ThinkPad logo is displayed during startup.
TransNote

R40, R40e, T40
Power on. Press the blue "Access IBM" button during startup when the message "To interrupt normal startup, press the blue Access IBM button" is displayed. Then select "Start setup utility" to run the BIOS Setup Utility.
Older ThinkPad Models
To Run BIOS Setup:
300350500, 510
Press CTRL+Alt+F3 at an MS-DOS prompt. The system must be in MS- DOS mode and not in a DOS session under Windows.
310, 315310E/ED315ED
Power on. Press F2 while the ThinkPad logo is displayed during startup.
365C/CS365CD/CSD365E/ED
Press CTRL+Alt+F11 at an MS-DOS prompt. The system must be in MS-DOS mode and not in a DOS session under Windows.
365X/XD
With the unit powered off, press and hold the F1 key while powering the unit on. Continue to hold the F1 key down until Setup appears.
360, 355 series380, 385 series560 series600 series701C/CS75x series76x series770 series
With the unit powered off, press and hold the F1 key while powering the unit on. Continue to hold the F1 key down until Setup appears. On the TP 701, you can also access BIOS Setup by pressing the Fn+F1 keys atanytime.
700/C, 720/C
Power on. Press CTRL+ALT+INS when the cursor moves over to the upper-right side of the screen, right after the memory count during startup.
710T, 730T
Press and hold the suspend/resume switch while powering on the computer.

Hi,
Thanks guys but as I said in my first POST F1 get me to the "Easy set-up program but I am not reaching the BIOS. As I said I have an TP760ed.

Any other suggestion.

/Claes

just a question what did you want to change in the bios?