Memory - [Answered] Memory configuration posted in the Hardware forums; Tried it afain and same error message again, the log is 1mb and upload limit is 145kb???...
Dont know if this will help but ill paste the memory section....
Property Value
Memory Summary
Location System board or motherboard
Maximum Capacity 8192 MBytes
Memory Slots 4
Error Correction None
Use System memory
Maximum Memory Module Size 4096 MBytes
Device Locator Slot 1
Manufacturer Corsair
Part Number CMX1024-3200C2
Capacity 1024 MBytes
Memory Type SDRAM DDR
Speed PC3200 (200 MHz)
Data Width 64 bits
Voltage SSTL 2.5V
Error Correction None
Refresh Reduced (.5x)...7.8 µs
EPP SPD Support No
Device Locator Slot 2
Manufacturer Corsair
Part Number CMX1024-3200C2
Capacity 1024 MBytes
Memory Type SDRAM DDR
Speed PC3200 (200 MHz)
Data Width 64 bits
Voltage SSTL 2.5V
Error Correction None
Refresh Reduced (.5x)...7.8 µs
EPP SPD Support No
Warning! Accuracy of DMI data cannot be guaranteed
Im gonna have to go to bed cos its early hours in the morning here, however ill have a look at your replies in the morning and get back to you.... Thanks for your replies.
Sorry about that, It all looks fine. I don't know why your BIOS is showing it that way. I wouldn't worry about it. If Windows and SIW check out fine, then you should be fine; unless you have been experiencing problems with it.
No problems as such but i wouldnt say my Pc was fast... especially on start up, by the way how cool is siw... it even tells me what underpants I wear lol, if only I knoew what it all meant!!
I recommend just watching the forum, you will gain quite a bit of knowledge. I know I did. Well, if it isn't running too fast, try doing the Prework from my signature and posting it in a new thread in the HijackThis logs section. The Security Team will take a look and make sure your computer is clean of malware, because that can cause huge performance issues and other problems.
PC Help Forum
» Hardware
» Memory
»
[Answered] Memory configuration
Re: Memory configuration
Well, if it isn't running too fast, try doing the Prework from my signature and posting it in a new thread in the HijackThis logs section. The Security Team will take a look and make sure your computer is clean of malware, because that can cause huge performance issues and other problems.
Linear Mode
