OKAY

So windows in now running.
Problem fixed.

BUT

I am getting that same error tooltip saying: "RAID Access Failure" then points to a HD. And this was the start of the whole catastrophe, so I want to figure out how I can keep this from happening again.
What do I need to do?

Are you sure you've properly installed the RAID0 drivers?

I think so. I never had problems the first couple . . . months(?) I've had it for.

Okay, so I havent been getting the error - but instead it just wont boot.
Sometimes it gets stuck on Detecting Array, or other times Verifying DMI Pool Data.
And now, when I go to boot, it will get past Verifying DMI Pool Data, and the next screen will prompt me how to boot windows, either in Safe Mode, Last Config. Settings that worked, or normally. And no matter what the **** I choose, this piece of **** just restarts. Makes no sense, it just turns off and then back on instead of starting Windows.


---------------------


Okay, so I am just going to reformat (again -.-), but this time I want nothing to do with RAID. How to I reinstall windows without RAID?

Ok.Do you have an extra computer?If so can you hook the harddrive up to it.Try to access it.If you cant because of a disk error or somthing it might be a bad harddrive.

I could - but after I do this, I will still want to reformat the computer and reinstall Windows without RAID, how would I do that? Because I need to install it so it will recognize the disks, and then after that I never get an option to not have it.