Hey for some reason when i try to burn a movie i have on my pc. It wont burn because i keep getting this error with my DVD burner. I keep getting "Power Calibration failed". I have cleaned out my DVD driver with a air gun and i have also disable the thing in the Services. I am not sure what could be wrong. I mean I can burn Cd's fine and it Reads Cd's fine also.

I know this is in the wrong section but ehmm i will get a faster reply in this section then the other.

I have cleaned out the DVD drive twice and still nothing. I am also using a good brand of DVD's i am using Sony and used a Phillips and the same thing happened

Hello Bighomedog, Welcome back to PCHF!

I have moved you thread to the correct forum - it is not a matter of speed, it is a matter of the most qualified person for your problem seeing your thread And I have also merged your other post with this one. Please keep to one thread per problem please!

Could you be more specific in what that was?

Also, what kind of burning software are you using?

Have you tried a fresh install of it?

I have marked this as open to attract the attention of one of our techs - someone will be with you as soon as possible

Regards,

Smokeycheech

The main cause of this error is cheap media, although you say that you are using quality disks.

Have you tried burning at a lower speed to see if this will stop the problem?

A firmware upgrade for the dvd burner may help as well...