I did this, the PC is working, just the monitor is staying off. Is this to do with the graphics card? At the back of the graphics card it has a 6pins, so i used a 6pin connector from my PSU to put into the graphics card. However when I baught this graphics card, it came with the image below.

http://i184.photobucket.com/albums/x...7/CIMG3695.jpg
This had 6pins in the black bit, and 3 silver pins on each of the white parts

my pc keeps entering powersave mode.

Can you run Belarc.com there advisour so I can have exact make and model of mainboard or do you know this?

Thanx

I cannot run belarc on pc, because PC keeps entering powersave mode - however I believe the motherboard is a Asus M2N61-AX Mobo

HELP!.for Dell Inspiron 531...[PIC] - Overclock.net - Overclocking.net


This is the Motherboard :P

If all your connections on mainboard are correct and make sure card is fully pushed in.

Does the computer power up all fans spin just the card not working?


Brilliant I could not find the make of baord.

All the fans are spinning and the one the graphics card is too.

I have the 24pin connecter connected to the 24pin slot which you said earlier, a connector from the Power Supply Unit to the hard drive another conected to the PSU to the cdrom, and a 6bit pin connecter from the back of the graphics card to the PSU.

PC Just keeps going into hibernate!

Really stuck! Any help!?